The Walther P38 was in production from to Only after was the P38 again produced for the German military.
Post war P1 grips were made of black colored plastic. Initial production P38 pistols were fitted with walnut grips, but these were later supplanted by Bakelite grips. The falling locking block design provides good accuracy due to the in-line travel of the barrel and slide. Two return springs located on either side of the frame and below the slide, having been compressed by the slide's rearward movement, drive the slide forward, stripping a new round from the magazine, driving it into the breech and, in the process, re-engaging the barrel ending its return travel with a fresh round chambered, hammer cocked and ready to repeat the process. The slide however continues its rearward movement on the frame, ejecting the spent case and cocking the hammer before reaching the end of travel. When the pistol is fired both the barrel and slide recoil for a short distance together, where the locking block drives down, disengaging the slide and arresting further rearward movement of the barrel. The moving-barrel design mechanism operates by use of a wedge-shaped falling locking block underneath the breech. The firing mechanism extracts and ejects the first spent round, cocks the hammer, and chambers a fresh round for single-action operation with each subsequent shot - all features found in many modern day handguns.
Pulling the trigger cocks the hammer before firing the first shot with double-action operation. This lever can stay down, keeping the pistol "on safe" or be immediately returned to the straight position, keeping the weapon safely "ready" with a double-action trigger pull for the first shot. The shooter could chamber a round, use the safety- decocking lever to safely lower the hammer without firing the round, and carry the weapon loaded. Several experimental versions were later created in.įrom an engineering perspective the P38 was a semi-automatic pistol design that introduced technical features that are found in other semi-automatic pistols like the Beretta 92 and its M9 sub-variant adopted by the United States military. After a few thousand pistols the Heer changed all codes from numbers to letters and Walther was given the "ac" code.
#Walther p1 frame crack code
The third series pistols satisfactorily solved the previous problems for the Heer and mass production began in mid, using Walther's military production identification code "". Dorena caroli storia delleducazione 2018/2019 nome e cognome
#Walther p1 frame crack serial
The P38 concept was accepted by the German military in but production of prototype "Test" pistols did not begin until late Walther began manufacture at their plant in Zella-Mehlis and produced three series of "Test" pistols, designated by a "0" prefix to the serial number. It was intended to replace the costly Luger P08the production of which was scheduled to end in The first designs submitted to the German Army featured a locked breech and a hidden hammer, but the Heer German Army requested that it be redesigned with an external hammer. The Walther P38 originally written Walther P.
0 kommentar(er)
